Guide
Jio WiFi not working? Fixes for JioFiber and AirFiber
Your Jio WiFi says connected, but pages will not load. This happens on JioFiber, JioAirFiber and JioFi when the connection goes idle or the router loses sync with the network. Here is what to check, in order.
JioFiber vs AirFiber vs JioFi
JioFiber is the wired fiber broadband service. The fiber cable plugs into your router, and you get speeds from 30 Mbps to 1 Gbps depending on your plan.
JioAirFiber is the wireless 5G fixed broadband service. No fiber cable. The router connects to Jio's 5G network over the air. It works in areas where fiber is not available.
JioFi is a portable WiFi hotspot device. It uses a SIM card and connects to the mobile network. If you have a JioFi, most of this guide still applies, but check the JioFi battery and SIM first.
Lights and what they mean
On a JioFiber router, look for these lights:
- Power: Should be solid green. If off, check the power cable.
- PON or Fiber: Should be solid green. If off or red, the fiber cable is disconnected or there is a network issue. Check the fiber cable at the back of the router and where it enters your home.
- LAN or WiFi: Should be solid or blinking green when devices are connected.
On JioAirFiber, the lights work differently because there is no fiber cable. Check the 5G signal light. If it is red or blinking, the router is not getting a good 5G signal. Move the router closer to a window or higher up.
192.168.29.1 router page
Open a browser and go to 192.168.29.1 (opens in new tab). This is the router admin page. The default username is usually admin and the password is on the sticker on the back of the router.
Check the WAN or Internet status. If it says disconnected, the router is not getting an IP from Jio. Restart the router and wait 2 minutes. If it still says disconnected, call Jio support.
Plan and recharge check in MyJio
Open the MyJio app. Go to your JioFiber or AirFiber connection and check the plan status. If your plan has expired or your account is suspended, the internet will not work even if WiFi is connected.
Recharge if needed. It can take 5 to 10 minutes for the connection to come back after a recharge.
Restart order
Turn off the router. Wait 30 seconds. Turn it back on and wait 2 minutes for all lights to stabilize. This clears the connection state and forces the router to get a fresh link from Jio.
If you have a separate ONT (the small box where the fiber cable comes in), restart that first, wait 30 seconds, then restart the router.
Stuck connection and WiFi Hammer
Sometimes the router goes idle and does not wake up when you try to load a page. This happens more on JioFiber than on other ISPs in my experience.
I built WiFi Hammer to fix this. It is a Chrome extension that wakes the connection with one click by sending real traffic to Fast.com and Netflix servers. Auto-hammer runs a light check every 5 minutes to 6 hours (30 minutes default, configurable) and only hammers after two failed checks. Hammer Hard runs a full speed test and can use a lot of data.
WiFi Hammer does not make your internet faster or increase your plan speed. It does not reset the router. It only wakes a stuck connection.
Jio support
If none of the above work, contact Jio support:
- JioFiber/AirFiber support: 1800-896-9999 (any phone, 24/7) or WhatsApp 70005 70005
- Use the MyJio app: Go to Help > Chat with us.
- Visit the Jio Contact Us page (opens in new tab).
When you call, tell them your router lights are on but you cannot load any pages. They can reset your connection from their side or schedule a technician visit.
FAQ
Why does my JioFiber say connected but nothing loads?
This usually happens when the router goes idle and does not wake up, or when the fiber link is down. Check the PON light on the router. If it is red or off, the fiber cable is disconnected.
What is the difference between JioFiber and JioAirFiber?
JioFiber uses a physical fiber cable. JioAirFiber connects to Jio's 5G network wirelessly. JioAirFiber works in areas where fiber is not available yet.
How do I check my JioFiber plan status?
Open the MyJio app, go to your JioFiber connection, and check the plan details. If your plan has expired, recharge it in the app or on the Jio website.
What does the PON light mean?
PON stands for Passive Optical Network. If the PON light is green, the fiber link is working. If it is red or off, the fiber cable is disconnected or there is a network issue.
Will WiFi Hammer work with JioFiber?
Yes. WiFi Hammer works with any broadband or router, including JioFiber and JioAirFiber. It wakes a stuck connection when pages will not load even though WiFi says connected.